Sauna Electrical Installation in Edmonton & Area
An electric sauna heater is one of the largest loads in a house. It needs a circuit sized to match, materials rated for the heat, and a connection you never have to think about again.
Get a free sauna install quote
Tell us about the job. We'll get back to you with a clear, honest price.
Request sent
Thanks. Jacob will be in touch shortly. If it can't wait, call (780) 915-2994.
Sauna Installs done properly
Electric sauna heaters typically run on 240 volts and can draw as much as a range or dryer. The circuit, the conductors and the connection to the heater and control panel all need to be matched to the heater's rating and installed with materials suited to high temperatures.
Whether you're building a sauna in the basement, converting a room, or setting up a barrel sauna in the backyard, we'll wire the heater, the controls and the lighting so it's safe, inspected and ready to use.
What we'll ask you
- Heater make, model and kilowatt rating
- Indoor or outdoor sauna, and where it will sit
- Location of the control panel or thermostat
- Any lighting you want inside the sauna
- Available space and capacity in your electrical panel
What's included
Every sauna install job from LOJ Electrical comes with the same standard.
Dedicated heater circuit
Breaker and conductors sized to the heater's rating.
Heat-appropriate materials
Wiring methods and fittings suited to the high temperatures inside a sauna.
Controls and lighting
Control panel, thermostat and interior lighting connected to the manufacturer's instructions.
Outdoor supply
For backyard saunas, a weather-rated disconnect and an underground or surface run from the house.
How it works
Four steps from first call to finished, inspected work.
Heater spec
We confirm the heater rating and control setup.
Panel check
Make sure there's capacity for the circuit, or plan a sub panel.
Rough-in and install
Run the circuit, set the controls, connect the heater.
Test and inspect
Heat-up test, inspection and a quick walkthrough.
Sauna Installs questions
It depends on the heater's kilowatt rating. Many residential heaters need a 240V circuit in the 30 to 50 amp range. We size it from your heater's nameplate.
Yes. We run a supply from the house, overhead or underground, with a weather-rated disconnect at the sauna.
Yes, the electrical work for a sauna heater requires a permit and inspection. We handle that for you.
Sauna Installs across Edmonton and area
We do sauna install work in every community we serve. Pick yours for local details.
Related services
Hot Tub Installs
Dedicated 240V supply, GFCI-protected disconnect and a clean run from panel to tub.
Learn more
Sub Panels
Extra circuits exactly where you need them: garages, shops, basements, hot tubs and additions.
Learn more
Custom Home Wiring
New builds, renovations and custom lighting, including deck and stair lighting that makes a house stand out.
Learn moreReady to talk about your sauna install?
Call now or send a quote request. Open 24 hours, 7 days a week.
Get your sauna install quote
Tell us what you're planning. You'll get a straight answer and an honest price, whether it's one circuit or a whole house.
Request a free quote
Name and phone are all we need to get started.
Request sent
Thanks. Jacob will be in touch shortly. If it can't wait, call (780) 915-2994.